Bolid Signal-10 Manuel d'utilisateur télécharger pdf (Page 37)

Signal-10 Operation Principles

37 www.bolid.com

OPERATING MODES

The Signal-10 device offers the following modes:

¾ Pre-Operation Mode

¾ Operation Mode

¾ Power Failure Mode

¾ Output Circuit Failure Mode

¾ Master Key Programming Mode

¾ User Key Programming Mode

¾ Self-Diagnostic Mode

¾ Device Failure Mode

For description of READY LED operation in different modes of the Signal-10 device, please refer

to Table 6.

Table 6. READY LED Behavior in Different Signal-10 Operating Modes

№ Operating mode LED Behavior

1 Pre-Operation Mode OFF

2 Operation Mode Lit with green

3 Master/User Key Programming Mode Double flashes with green every second

4 Power Failure Mode Flashes yellow once per second

5 Self-Diagnostic Mode Flashes red twice per second

6 Device Failure Mode Flashes red four times per second

7 Output Circuit Failure Mode Flashes red once per second

Pre-Operation Mode

When supply voltage is applied to power terminals, the device activates and switches to the Pre-

Operation Mode. The device power-up time doesn’t exceed 3 seconds provided that 11V or higher is

available at least at one power input.

Operation Mode

After the Pre-Operation Mode the device switches to the Operation Mode. In the Operation Mode the

device provides its main functions, those are alarm loop monitoring, fire alarming, trouble monitoring,

built-in relay performance monitoring and control. When used together with the Orion network control-

ler, the Signal-10 also communicates data with the network controller.

Please note, that the device sounds with a melody and the READY LED is switched on with green to

enable user to easily recognize that the device has successfully switched to the Operation Mode.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 95 96

Pas de commentaire

Bolid Signal-10 Manuel d'utilisateur Page 37