Bolid Signal-10 Manuel d'utilisateur télécharger pdf (Page 36)

Orion ISS

www.bolid.com 36

ELECTRONIC KEYS

In order to arm and/or disarm alarm loops of the Signal-10 locally, electronic identifiers (keys) are used

which are to be registered in the device memory along with related access rights. For this purpose, an

external reader has to be connected to the Signal-10. When a user touches the external reader with an

electronic key, the device automatically reads a code of this electronic key and checks its rights for re-

quested operation.

The Signal-10 device enables to read, store in its memory, delete, and change parameters of two dif-

ferent types of keys:

¾ User Keys

¾ Master Keys

Key programming procedures are described in details in Key Programming Section on the page 82.

User Keys

The User Keys are designed to arm and/or disarm alarm loops. Each User Key can be related with a

group of the Signal-10 alarm loops which will be armed and/or disarmed as a whole. The User Key can

have the following rights for each alarm loop of the Signal-10:

― arm or disarm

― disarm only

― arm only

― neither arm nor disarm

The combination of rights assigned to a key for each device alarm loop is called Key Status.

Controller memory can store 85 User Keys maximum.

Master Keys

Master Keys are designed to switch the Signal-10 to the User Key Programming Mode (see the page

38). This mode enables to add new User Keys or change access rights of existent User Keys by hard-

ware (see Programming of User Keys by Hardware Section of this Manual).

A Master Key cannot be used to arm/disarm alarm loops or change other device settings.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

Pas de commentaire

Bolid Signal-10 Manuel d'utilisateur Page 36