Bolid Signal-10 Manuel d'utilisateur télécharger pdf (Page 9)

SIGNAL-20P SPECIFICATIONS

can be considered as linearly increasing together with the detector con-

sumed current increments.

So the device useful current can be calculated in accordance with the

formulas:

The supply voltage being equal to 12 V,

I = 3,33×i + 400 [мА]

The supply voltage being equal to 24 V,

I = 1,67×i + 200 [мА]

where I is the common device consumed current (without regard to

external notification devices) expressed in мА

i is the consumed current of active detectors included into the

device alarm loops expressed in мА

The common reserve time is calculated by formula

T = 1000 × W/I hours

W is the accumulator capacity in А⋅ч

I is the device consumed current in мА

The device in operating mode supplies loop inputs by from 19 to 22 V

DC voltage provided the terminal resistance is equal to 4,7 kОhm ±5% and

the detector consumed current doesn’t exceed 3 mА. This voltage level is

kept even in case of short circuit failure in one of the alarm loops. More then

4 loop short failures together are not allowed. The short closed loop current

is restricted by 26,5 mA.

The ripple voltage effective value does not exceed 20 mV.

If burglary detectors are included into the alarm loop (burglary alarm

loop) the device provides in operating mode:

- the value of loop resistance being equal no more than 1 kOhm with-

out regard to external element;

- the value of leakage resistance between wires or between any wire

and ground being equal no less than 20 kOhm.

If fire detectors are included into the alarm loop (fire alarm loop) the

device provides in operating mode:

- the value of the loop resistance being equal to value no more than

100 Ohm without regard to external element;

- the value of leakage resistance between wires or between any wire

and ground being equal no less than 50 kOhm.

The device’s loops are resistant to electromagnetic effects being

harmonic electromagnetic pickup with 50 Hz frequency and 1 V effective

voltage.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 56 57

Pas de commentaire

Bolid Signal-10 Manuel d'utilisateur Page 9