Bolid Signal-10 Manuel d'instructions télécharger pdf (Page 2)

To build the detector into a suspended ceiling use separately purchased mounting kits MK-1 (variant B) or MK-2

(variant C). The size of mounting hole is shown in Figure 2, at the right.

DIP-34PA Smoke Detector

Mounting Base

Light Emitter

МК-1 Suspended Ceiling Mounting Kit

Base Aligning Mark by Light Emitter

МК-2 Suspended Ceiling Mounting Kit

Mark and Rectangle (Open here)

* are purchased separately

Figure 1 Three Ways to Mount the Detector

Figure 2 Drilling Pattern

WIRING

Figure 3 shows the wiring diagram to connect DIP-34PA detectors to an alarm loop of the Type 14 of a Signal-10 panel.

Figure 3 Wiring Diagram

INDICATION

Light Emitter Behavior Detector Status/Condition

Flashes once per 8 seconds Norm

Two flashes once per 8 seconds Fire Alarm; Test

Three flashes once per 8 seconds Dusty; Trouble

Three flashes (flickering) once per 2 seconds DIP-34PA is connected to an alarm loop of the Type 14; the detector’s

address has not yet been assigned

Four flashes once per second Being connected to a non-addressable alarm loop or dc power supply,

DIP-34PA is waiting for assigning an address

PROGRAMMING

In order the DIP-34PA to operate properly within a Fire Threshold Addressable Alarm Loop of a Signal-10, the detector

must be assigned to a unique number from 1 to 10 within the loop – the address which is stored in the DIP-34PA non-

volatile memory. The detector is delivered without any address. Not assigning a detector connected to a Fire Threshold

Addressable Alarm Loop of a Signal-10 to an address is indicated by flickering of its light emitter once per two seconds.

Signal-10

DIP

1 2 3 4

Pas de commentaire

Bolid Signal-10 Manuel d'instructions Page 2